Grubs Boots FAQ

It's all in the design. All GRUBS® boots are 100% waterproof keeping feet warm, dry, and protected in harsh weather and messy working conditions. The secret - our exclusive self-insulating waterproof Insu-foam Ultra™ shell construction. The Insu-foam Ultra™ bootie material acts as a "neutral medium" between inside and outside temperatures. Naturally lightweight, buoyant, and very comfortable, the material keeps the foot and lower leg warm and protected in cold and wet conditions.

Natural rubber overlays act as a protective skin for the upper bootie. The upper has a triple reinforced toe area and a quadruple reinforced heel area. The outsole is made of high abrasion natural rubber. The rubber in the boots will stay flexible for years.

• Grubs Boots Size Guide

Thinsulate, made by 3M Corporation, is typically used in work boots and hiking shoes to resist cold temperatures. Thinsulate is typically laminated to the whole shoe lining or glued into the toe area of a shoe or boot. It is not a waterproof material. Gore-Tex is a breatheable, waterproof membrane but is not an insulating material. The Insu-foam Ultra™ foam used in GRUBS® is both waterproof and self-insulating. Our materials exceed the long-term effectiveness of waterproof membrane materials and provide greater insulating properties than all non-specialty temperature-control substrates.

Unlike many pac boots, GRUBS® do not have an inner felt liner. Felt liners are very hot and can cause skin irritation with prolonged use. One of the most important and revolutionary features of GRUBS® footwear is the structured, breatheable Superdri™ lining used in some of our products. Superdri™ is made up of thousands of tiny vertical fibers that allow air to circulate throughout the interior lining surfaces. Excess humidity and perspiration that might build up in the boot are quickly wicked away. This creates a comfortable environment for your feet that lasts for extended periods of use.

Standard U.K. sizes for men and women (unisex sizing). Boots and shoes are available in whole sizes only, but will stretch to fit half sizes. There is a 15mm toe allowance built into the sizing.

• Grubs Boots Size Guide

Yes. Our boots are made to standard widths, but the materials will stretch comfortably to fit widths up to a EEEE. For narrow feet, we suggest wearing a thicker sock or putting in an additional footbed to take up room.

• Grubs Boots Size Guide

No. The upper calf and topline areas are made of soft, flexible Insu-foam Ultra™ foam and will "stretch-fit" to virtually any calf girth. With the flexible upper, the pant leg can be worn over or inside the boot. The collar material can be turned down to allow hands-free removal and vent humidity in warmer working conditions.

• Grubs Boots Size Guide

It isn't necessary unless activities are planned for extreme cold conditions. The Insu-foam Ultra™ foam bootie material is rated sub-zero during active use and will effectively withstand freezing temperatures for up to one hour. Medium-weight athletic socks should provide the best fit. The upper will stretch to accommodate thicker socks.

• Grubs Boots Size Guide

Whilst the rubber and nylon upper are very durable, it is essential to ensure that you maintain them with regular cleaning and conditioning.

We recommend hosing down your wellies after each use and once a month wash off excess dirt with just water and for a deep clean use water with a mild soap. Gently scrub with a soft bristle brush until your boot is clean, then leave the boots to dry naturally (not on a direct heat source).

Once dry, we recommend a rubber conditioner or natural oil to replace the lost plasticising agents in the rubber. The rubber upper can be conditioned with a natural mineral oil such as baby oil however Grubs Boots Limited recommends the use of McNett Revivex spray which is available from leading retailers.

Please note, it is not recommended to use conditioners on the outsole areas. This may cause it to become slick in wet or icy conditions.

Yes. The natural rubber can be repaired with sealant found in local hardware stores. We recommend STORMSURE® brand rubber sealant. First, clean the punctured area thoroughly with mineral spirits. Then, apply the sealant over the affected area and wipe to a thin film. The sealant should air dry for at least 24 hours.